Welcome To Visit Shanghai Linglam Electric Co., Ltd
Products
pure sine wave inverter with charger

pure sine wave inverter with charger

pure sine wave inverter with charger
DC to AC inverter, low frequency, pure sine wave, with built in battery charger
DC 12v/24v/48v and AC 100v/110v/120v/220v/230v/240v input
AC 100v/110v/120v/220v/230v/240v output
1000w-12kw

On Inverter
high overload ability
low battery voltage trip selectable, extracting max power from various batteries with different protections
low quiescent current, selectable sensing cycle to reduce power consumption


On Battery Charger
3-step intelligent battery charging
8 preset battery type selector plus de-sulphatin for totally flat batteries
powerful charge rate up to 70Amp, selectable charging current
PFC(power factor correction) for charger, less power consumption than conventional units.


On Transfer
delat before transfer, extra protection for loads under generator mode
input AC voltage range selectable, for different kinds of loads
8ms typical transfer time, guarantees power continuity
30A/40A through current ability
output voltage regulation optional


On Remote Control & Other Feaures
ability to switch the unit on/off
ability to select/diselect power saver mode
17 alarms/ warnings, informative for easier operation and trouble-shooting
LED status display available
RS232 communication port optional

Norminal Power 1000W 2000W 3000W 4000W 5000W 6000W
AC Input Phase & Waveform                                           Single phase & pure sine wave
Voltage 100/110/120/220/230/240VAC
Acceptable Voltage 194-243VAC \ 164-243VAC (wide mode)
Line Low Transfer 85V ± 4% / 184 (154 wide mode ± 4%)
Line Low Return 95V ± 4% / 194 (164 wide mode ± 4%)
Line High Transfer 135 ± 4% / 253±4%
Line High Return 127 ± 4% / 243±4%
Frequency 50Hz or 60Hz (auto sensing)
Line Low Transfer 47Hz for 50Hz, 57Hz for 60Hz
Line High Transfer 55Hz for 50Hz, 65Hz for 60Hz
Output Phase & Waveform Single phase & pure sine wave (bypass mode sync to input)
Voltage 100/110/120/220/230/240VAC (sane as input on bypass mode)
Voltage Regulation ± 10% rms (bypass mode sync to input)
Frequency 50Hz or 60Hz (auto sensing)
Crest Power 3 times of ratings
Short Circuit Protection Yes, shutdown after 10 minutes
Power Factor 0.9~1
DC Input Battery Voltage 12/24V 12/24/48V 12/24/48V 24/48V 24/48V 24/48V
Minimum Start Voltage 10V for 12V, 20V for 24V, 40V for 48V
Low Battery Alarm 10.5V for 12V, 21V for 24V, 42V for 48V
Low Battery Transfer 10V for 12V, 20V for 24V, 40V for 48V
High Voltage Alarm 16V for 12V, 32V for 24V, 62.8V for 48V
Max Charging Current 20A-75A
Over Charge Voltage 15.7V for 12V, 31.4V for 24V, 62.8V for 48V
Transfer Efficiency               Line Mode >95%
Battery Mode >85%
Power Saver Available when the load is less than 50 Watts
Indicators

 

 

 

 

7-LED Display

 

 

 

From the right to the left:

LED1 line mode (green lighting);

LED2 inverter mode (green lighting);

LED3 charging mode (yellow lighting);

LED4 Fully Charged (green lighting);

LED5 over heat shutdown (red lighting);

LED6 Overloaded shutdown (red lighting);

LED7 Saving Mode (green lighting)

 
3-LED Display Charging Mode (green lighting)inverter mode (green lighting)Alarm (red lighting)
LCD Display Input VoltageOutput VoltageFrequencyBattery VoltageLoad
Switch selector Saving Mode is on/off when push the switch forwards/backwards, keeping it horisontal is turning the inverter off
Audible Alarm Sounding when the heatsink's tem is over 105ºC and shutdown after 30 seconds
Protections low batteryover chargingover tempover load
Communications RJ11/RS232 (Optional)
Environmental Operating Environment 0-40℃0-90%RH (non-condensing)
Audible Noise <60dB
Physical
Net Weight (KG) 14 19 23 35 44 44
Dimension (mm), D*W*H 218*179*442 218*179*598

Normal Power 8000W 10000W 12000W
AC Input
Phase & Waveform single phase & sinewave
voltage 220V/230V/240VAC
Acceptable Voltage 154-273VAC
Line Low Transfer 154V
Line Low Return 164V
Line High Transfer 273V
Line High Return 263V
Frequency 50Hz or 60Hz (Auto Sensing)
Line Low Transfer 40Hz
Line High Transfer 80Hz
Output
Phase & Waveform Single phase & sinewave (bypass mode sync to input)
Voltage 220V/230V/240VAC (sane as input on bypass mode)
Voltage Regulation ±10%rms (bypass mode sync to input)
Frequency 50Hz or 60Hz (Auto Sensing)
Crest Power 3 times of ratings
Short Circuit Protection Yes, shutdown
Power Factor 0.9-1.0
DC Input
Battery Voltage 48V
Minimum Start Voltage 40V
Low Battery Alarm 44V
Low Battery Transfer 40V
High Voltage Alarm 64V
Max Charging Current 75A 85A 100A
Over Charge Voltage 62.8V
Transfer Efficiency
Line Mode >95%
Battery Mode >85%
Power Saver Available when the load is less than 75 Watts
Indicators
4-LED Display Charge, Line, Inverter, Fault
LCD Display Input Voltage, Output Voltage, Frequency, Battery Voltage, Load, Temperature, Charge Current, Fault
Switch selector Saving Mode is on/off when push the switch forwards/backwards, keeping it horisontal is turning the inverter off
Audible Alarm Sounding when the heatsink's tem is over 105℃ and shutdown after 30 seconds
Protections low battery, over charging, over temp, over load
Communications RJ11/RS232 (Optional)
Enviromental
Operating Environment 0-40ºC,0-90%RH (non-condensing)
Audible Noise <60dB
Physical
Net Weight(KG) 56 64 68
Dimensions,D*W*H(mm) 549*450*201.2 584*450*201.2

 

 

 

 

 

 

 

Contact

Tel: 0086-021-39216251

Products
Solution
Case
FAQ
About us

Copyright © Shanghai Linglam Electric Co., Ltd

top